Volvo S60 II, V60, V70 III, XC60, XC70 II and S80 II — P3 platform maintenance and repair guides.
To replace rear brake pads, you need a device that can move the brake cylinder pistons to service position. This can be done with a newer Bosch tester...
The instructions apply to almost all magnetic clutch compressors. The principle is to reduce the gap between the magnetic clutch plate and the pulley ...
From Volvo, the entire magnetic clutch assembly costs about 330 euros. The bearing alone costs about 60 euros including postage. The work takes 3-4 ho...
V70 III bi-xenon low beams leave the left lane (oncoming traffic side) quite dark. This is due to the shade positioning inside the housing....
The rear door locks begin to stick so that the locks do not always close properly. Opening works, but locking does not. The problem is initially rando...
The most common cause is the pinion shaft front bearing wearing out. The problem affects almost all all-wheel drive P3 platform models....
The swivel bearing is a bearing at the top of the suspension strut, bolted from the engine side. It allows the strut to turn with the steering....
The car reports a steering lock problem while driving and asks to stop. After shutdown, the car will not start anymore. The problem can start as rando...
The pump is located between the oil dipstick and the oil filter cap — it appears as a small cylinder on the side of the engine....
1. Disconnect the heater core hoses from the engine compartment side: spread the plastic ring wrench fingers and push the ring towards the firewall. 2...
The linkage operates two flaps and a servo motor controls one additional flap — meaning three flaps turn at the same time. The linkage is attached to ...
Search Volvo forums in seconds
Try HIPO free →Käytämme evästeitä sivuston kehittämiseen. Hyväksytkö analytiikkaevästeet? Lue lisää